Submit a Help Request (804) 828-2227 | itsc@vcu.edu

Program a One Touch Dial Key

ISDN 1050/9924

  1. Press REG (softkey) 4 of the buttons directly below the display screen)
    • Press [1] on the keypad
    • Press ENTER (softkey 1 of the buttons directly below the display screen)
  2. Press the One-Touch Message Speed Dial key or any of the available multifunction buttons that are not programmed as telephone lines.
  3. Dial [9] + the NUMS access number 1-877-584-9321 or any other number you want to program. Remember to include [9] if programming an off campus number.
  4. Press ENTER (Softkey 1 of the buttons directly below the display screen). COMPLETED appears on the display
  5. To exit, press REG (softkey 4)

ISDN 970
This set has 5 one-touch memory locations.

  1. To assign a one-touch memory button, press [MENU] .
    • Press the softkey below MEM .
    • Press the softkey below 1TOUCH .
    • Press the softkey below PROGRAM . The following display appears:
      Enter phone #:
      _

      PAUSE QUIT
  2. Enter [9] + the NUMS access number 1-877-584-9321 or any other number you want to program. Remember to include [9] if programming an off campus number.
  3. Press the softkey below DONE when you are finished.
  4. Press a memory key to store this number.
    • Remember, the memory keys are the bottom three keys plus the [LOWER] key.
    • The keys are numbered M1, M2, and M3.
      •  Each key has two positions: press [LOWER] to access the lower position.
      • [REDIAL] occupies the upper M1 position.
  5. You can write with pen or pencil on the top of the plastic cover that surrounds the keys to remember the autodial destination.



This article was updated: 07/2/2013